Partenaire de développement de tissus pour le prêt-à-porter féminin — MOQ sur mesure de 300 m, stock disponible à partir d'un rouleau, pour marques, usines et grossistes.

A Slub Found After Sewing: Whose Claim, Whose Cost?

D
Delia Équipe éditoriale de Fursone
Published on Nov 16, 2026
Lecture de 10 min

The mill’s offer to pay for the cloth and nothing else is not a rule of law. It is a limitation of remedy, and a commercial buyer is normally held to the one it signed. Whether the remake charge lands on the mill turns on two papers rather than on where the slub was born: a purchase order that said, at signing, what the cloth was for, and a notice given inside a reasonable time. The fault itself is a fact. The money is a document question, and the documents are dated.

Four Ways the Remake Charge Can End: Which One Are You In?

Your cutter has sewn the coat, found a thick place running across a front panel, and is holding a remake charge. The mill has offered the cloth. Between those two positions sit four settlements, and they are not four versions of one idea. Each recovers a different loss, each runs under a different contract, and each needs a different paper before it can move. Pick the settlement before you argue about the yarn, because the settlement decides which loss the meeting is even about, and only one of the four puts a garment back on the line this month.

How Do the Four Settlements Compare?

A settlement here is a mechanism rather than a mood, and the comparison turns on what each one actually recovers.

Settlement What it recovers What it needs in writing Effect on the garment programme
Re-cut from the balance The lost panels plus the cutting hours A marker showing the fault sits in a strip that can be recovered Keeps the run in one dye lot and holds the date
Replacement yardage, same lot Metres of cloth, not sewing labour The roll ticket and a lot number on the replacement Keeps the shade match, if the lot still exists
Shared remake Part of the sewing cost, negotiated An allowance both sides sign before the panel is re-cut Restarts a panel and puts the deadline at risk
Credit note Money against the invoice The invoice reference and the clause relied on Does nothing for the programme at all

Read the middle column first. A settlement that recovers cloth cannot pay a sewing bill, and a settlement that pays cash cannot match a shade.

Why Does the Clause Decide the Money Before the Slub Does?

The order of operations is clause, then date, then origin. First, read what the contract says about remedy, because that term fixes the measure of damages before any inspection report is opened. Second, fix the date you discovered the fault and the date you told the mill, because late notice closes every remedy at once. Third, and only third, argue about the yarn, since a fault proved to have come from the spinner still meets the clause you signed. A buyer who opens with the slub spends the meeting on the one question that changes nothing. In practice, the letter that wins is written in this order, and the day-one claim sequence is the same order applied to short or wrong cloth.

Does a Yarn Fault Above the Mill End Your Claim?

A slub is a yarn-level fault: a thickened, irregular place made by fibre clumping or by uneven spinning, and it can survive weaving, dyeing and finishing. The spinner may well be its cause. That fact does not move your claim, because your contract is with the weaver, and the weaver’s recourse against a yarn supplier is the weaver’s own commercial problem. The conformity duty runs from the mill to you; a separate supply claim runs from the mill to its spinner, and you are not a party to it. A mill that says the fault came from upstream has answered a question nobody in the room asked, and it has not answered yours, which is whether the delivered cloth conformed. Where the fault sits is a different question again, and the attribution argument when a seam fails shows how cloth and making are separated when the evidence is thin.

Is Fabric Value Only a Rule, or a Clause You Signed?

It is a clause, and it is the most useful sentence in the file. Default rules in a sale of goods fill gaps the parties left open; they do not survive a term the parties actually wrote. A mill offering fabric value only is not quoting a statute. It is quoting its own order confirmation, and the real question is whether that term reached you before you accepted the cloth, in a document you signed or in one you did not object to.

What Does a Limitation of Remedy Provision Allow?

A limitation of remedy is a term that fixes the measure of damages, and the sale of goods default lets the parties write one. According to Iowa Code chapter 554 (Iowa 2025), the agreement may limit or alter the measure of damages, and consequential damages may be limited or excluded unless the limitation is unconscionable, with a limitation for commercial loss expressly not prima facie unconscionable. Two limits on such a cap matter to a buyer. 1. An exclusive remedy that fails of essential purpose reopens the general remedies, so a mill unable to supply replacement cloth cannot stand behind a cloth-only cap. 2. A cap reaches only the loss the clause described. In practice, the argument is never about whether a cap exists. The argument is about which layer of loss the cap reaches.

Why Are Three Loss Layers Three Separate Claims?

A loss layer is one stage of the damage, and each stage runs against a different party on a different test. First, the cloth: metres consumed, measured under the fabric contract against the mill. Second, the cut-and-sewn garment: the panels already spent plus the sewing labour, recoverable from UCC 2-715 (2025) only as consequential damages, and only if your order disclosed the garment programme. Third, the downstream loss: a missed drop, air freight, a cancelled order, which is the layer most often excluded and the layer no fabric file can prove. The phrase remake cost merges all three into a single number, which suits the party paying it. Separate them in the letter, because one merged figure is argued as one term, while three figures are argued as three separate heads of loss with three separate proofs. For example, a letter that demands the remake as one number invites one clause in reply.

What Makes the Remake Recoverable? Two Papers and a Marker.

The remake is not recoverable because the slub is bad. It is recoverable because a first paper told the mill what the cloth was for, a second paper told the mill in time, and a third document shows the fault could not be cut around. The third is the cheapest of the three, and both sides already hold it.

Cutting table at the end of a shift with a dark wool tweed panel spread flat, a thick slub running across the weave, and a paper front-panel pattern piece laid over it so the fault falls inside the outline

What Must the Purchase Order Disclose at Signing?

The test is what the seller had reason to know at the time of contracting, not what the buyer explained afterwards. According to the consequential damages provision in UCC 2-715, a buyer may recover loss resulting from general or particular requirements of which the seller at the time of contracting had reason to know, and which could not reasonably be prevented by cover. Three disclosures close that gap. First, name the end product and the panel: a coat, a chest panel, a two-way match, not tweed in general. Second, name the programme date the cloth feeds. Third, name the quantity exposed at that date. A purchase order listing tweed, quantity and price has bought a cloth remedy, and no complaint written after the coat was sewn repairs it.

What Must the Notice Say, and How Soon?

Notice is a document, and a complaint is not a notice. According to the notice provision in Iowa Code chapter 554, after acceptance the buyer must notify the seller of breach within a reasonable time after discovering or being able to discover it, or be barred from any remedy. Acceptance bars rejection; it does not by itself impair other remedies, but the burden of establishing the breach stays with the buyer. A usable notice carries five things: the date and place of discovery, the roll and lot, the metres affected, the panel position against the marker, and the remedy claimed. Send it to the mill and not only to the factory, and keep the dispatch record. A friendly call to a salesperson is not a notice.

Is It a Re-Cut or a Remake? The Marker Answers.

A marker is the layout of pattern pieces on the cloth, and it decides the cost of a fault more than the fault does. Photographs answer whether the slub exists. The marker answers whether it can be avoided. First, ask where the fault sat relative to the panel outlines, since a thick place inside a chest panel is a remake while the same place in a strip between two panels is a length of cloth and an hour at the cutting table. Second, ask whether the lay was one way or two way, because a two-way lay can sometimes shift a piece and a one-way lay cannot. Third, ask how many plies were spread, since a fault through the lay reaches every ply. A cutter reads all three from the spread record in minutes, and the lot-fail decision is the earlier version of this question.

What Do You Send This Week, and What Goes in the Next Order?

Two letters leave your desk this week, and they are different letters. One goes to the factory and asks for the spread record, the marker, the cutting ticket and the inspection sheet from before the lay. The other goes to the mill and states the breach, the date of discovery, the metres and panels affected, and the remedy claimed. Neither letter argues fault. The next order is where the argument stops repeating, and it is a clause list rather than a paragraph.

Which Clauses Cover Slubs, Fuzz and Pilling?

A clause list for appearance defects is shorter than most buyers expect, and every line has one job.

  1. A named appearance standard with an agreed acceptance limit, because a grading method and a quality level are two different things.
  2. A pre-spread inspection, with the method, the lighting and the inspector named.
  3. A defect limit in the same unit the standard uses, so the limit and the report can be compared.
  4. A notice window in days and a stated form of notice, since reasonable time is argued after the fact.
  5. A remedy menu in order, with the marker as the test for a re-cut.
  6. For fuzz, nap and pilling, a named test method and a stated wear condition rather than a promise of no pilling.

The two usually missing are the notice window and the remedy order, and the settlement ladder after a pilling failure shows what the argument costs when the order of remedies was left open.

Why Will CGL Insurance Not Pay for the Remake?

A commercial general liability policy responds to bodily injury and to damage to other people’s property. It does not respond to the cost of repairing the insured’s own defective material, and a remake is exactly that cost. Two consequences follow. First, the remake is a contract claim or it is nothing, so the order terms and the notice carry the entire weight. Second, a rip and tear argument, where removing faulty cloth damages the garment around it, depends on policy wording and is not a plan. Ask the broker in writing before the claim and not after it. A supplier certificate of insurance is not a remedy, and it never belongs in a settlement letter.

What Is the Order of Payment, and Who Proves What?

The settlement ladder runs from cloth to cash, and cash is the last rung. First, re-cut from the balance of the same roll or lot, which keeps the dye lot and the deadline. Second, replacement yardage from the same lot, which keeps the programme alive at the cost of a day. Third, a shared remake, priced from the cutting record rather than from a quotation. Fourth, a credit note, which settles an invoice and rescues nothing, because fresh weaving is a new dye lot and the coats will not match. Proof splits two ways: you carry the burden of establishing the breach per UCC 2-607, and the mill carries the burden of showing a limitation clause was part of the contract. For example, whoever produces the signed order confirmation first sets the terms of the meeting.

Delia

Laisser un commentaire

Retour en haut
Besoin d'un devis rapide ? Discutez avec notre équipe export sur WhatsApp.